flat top knuckles/spindles/10boltstubshafts

[J Cooper]

looking for a pair of
chevy dana 44 flat top knuckles with the small bearing spindles, and some 10 bolt stub shafts... a couple pairs if you got em

(going to put them on my 30 with ford hubs and rotors with the chevy calipers.... i gain high steer, get rid of drop pitman, bigger u-joints and internal splined hubs)

looking for all these parts, but if anyone has any of them let me know. or if your going to a yard anytime soon, keep your eyes open

[eight]

So what you gonna do about inner shafts to match the 10 bolt stubs?

[J Cooper]

which part you talking about... the ears? have em drilled out or use an adapter u-joint

or do you mean the 10 bolt stuff wont work.. what should i use instead?

[eight]

Yea I've heard of having the ears drilled out. I wonder what the difference is in the ear size, I know there's more metal around the hole on a d30 shaft than a d44 one. Then weld the caps in and call it done.

If you don't know, a chevy d44 stub shaft is the same as a 10 bolt one, and I think waggy ones are too.

[J Cooper]

ok, that sounds good too, i was just saying 10 bolt because i knew they were easier to find, i was gonna use the 44s if i could find them

[AgDieseler]

10 bolts and 44s both use the 297x joint, so you're good there. You'll need to pick your bearing hub based on what stub shaft you want to run. A 10 bolt has a 28 spline stub, and only a 10 bolt hub (6 or 8 lug) will work.

Chevy guys slap 44 knuckles on 10 bolts all the time. They are able to retain all the outer stuff since 10 bolt spindles/hubes/bearings/shafts bolt onto 44 knuckles.

[eight]

I'd like to see this 28 spline stub......

[J Cooper]

Originally posted by AgDieseler
10 bolts and 44s both use the 297x joint, so you're good there. You'll need to pick your bearing hub based on what stub shaft you want to run. A 10 bolt has a 28 spline stub, and only a 10 bolt hub (6 or 8 lug) will work.

Chevy guys slap 44 knuckles on 10 bolts all the time. They are able to retain all the outer stuff since 10 bolt spindles/hubes/bearings/shafts bolt onto 44 knuckles.

im gonna use the chevy small bearing spindles, they hold the ford 5 on 5.5 bearing and rotor, 10 bolt works with it.

[AgDieseler]

Originally posted by eight
I'd like to see this 28 spline stub......

Next time I take my hubs apart I'll call you.

[J Cooper]

Originally posted by AgDieseler
Next time I take my hubs apart I'll call you.

... you got served

[eight]

Originally posted by J Cooper
... you got served

nope, not till I see um.

[BigRedFord04]

I need a pair of chevy stub shafts also.