the rattle can paint job is nearing completion, I imagine it would look pretty good with some wet sanding and a clear. Has anybody ever used the spray can clear? Hopefully this stuff sticks, I scuffed, cleaned and acetoned the whole body (and some bondo work)
two notes:
-When estimating number of cans, double it
-don't use rustoleum sandable primer, it is expensive and ****.
Born to Kill
Originally Posted by RCcola55
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
Hey man, that actually looks pretty damn clean. Especially for a rattle can... nice job.
not too bad I guess, hope it lasts
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
Comparatively, that's the best flat-ish black I have ever seen on a vehicle minus a few custom jobs and supercar factory stuff.
And me encanta flat black
Looks good Travis, nice color
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
"It's not cheating if you pay for it"
It's not flat black....its a charcoal metallic
The test fender came out more shiny and metalic... But I do like the flatness
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
From my experience with rattle can clear coat, do not spill any gas on it while filling up, it will f' up big time
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
A little more meaningless work
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
Should I cut the rear quarter panels and build a bumper/slider that wraps, or just go with a simple bumper? This will be for temporary DSO wheeling until it becomes a baja-racer...
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
Leave it.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
grille painted and installed
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
I would go with a more simple bumper, if it is just going to be temporary
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
"It's not cheating if you pay for it"
What is wrong with the tail lights?
Needs new headlights.
I say cut the rear quarter and do wrap around bumper.
Looks good.
92 YJ
04 F-150 4x4
11 F-250 4x4
Posting Permissions
Reply With Quote
