-
Yo soy tu papa!
My NP241 was only hardened on the surface. I believe most of these shafts are induction hardened.
I chopped a slice off with the EDM and then did hardness tests across the cross section...
Edit: other than lining the cases up, the intermediate shaft is the only real big pain in the ass.
Doesn't your dad have a dividing head? That's the real key for splining.
Last edited by Doug Krebs; 09-01-2009 at 10:44 PM.
1988 Blazer...RIP
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules