I have done an impressive amount of nothing... I need to schedule a weekend to knock it out.
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
Decided to finally finish my skid plate. Made some good progress today. I should be able to finish it this week.
Decided to finally do something about the huge hole in my floorboard.
Mockup
Getting started
Next time I do sheet metal work I'm investing in a brake.
I still need need to fill in some spots and I'm going to get some rubber material to close off the whole bottom part.
Picked up an old mc2100 off eBay. Rebuilt it last week and got it on and fired up today.
Old vs new
The Venturi assembly as a crack so it will be getting replaced.
Sitting in place.
Anyone have an idea what this extra linkage part is for? It is sitting just inside the throttle linkage.
It spins about 90* freely .
I took the jeep for a spin earlier and I'm happy with the new carb. The throttle response is great. I still need to tune it better. Right now it is idling high. Later I will do some of the mods to help it perform better.
What did the carb come off of? That could be a clue. We have some trucks at work with hand throttles that have extra linkages.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
What kind of choke is on that carb? Looks electronic, is it tied to the high idle during choke? Like would that linkage keep the throttle blades from closing?
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
Sooo, this happened.
Thanks to Karl for letting me barrow his receiver winch.
I used my wife's xterra to get unstuck.