The Murphy Belle

[BMFScout]

I bet if he didn't there will be at least one "good" side

[BMFScout]

Flem does like to poop alot!

[agjohn02]

you should get st john to build those brackets out of folded sheet metal for you.

[Graystroke]

nah, billet would look better.

[BMFScout]

Then I'd have to clamp them to the roll bar.

[robertf03]

Hey Jimmy do you have that 1/8" plate behind your shop that I used for my rockers? I built one bracket out of 1/16" because thats all I had and I think it needs to be thicker.

[BMFScout]

I probably have something we could use, I have 3/16" for sure.

The PSC lines came in, so that should be together fairly quickly, just have to hook up the hoses. You coming over?

[robertf03]

can't tonight, will stop by tomorrow

[BMFScout]

sweet, we'll drink beer and install a grab bar.

[BMFScout]

It's easy to tell when you have the ram plumbed backwards! You just touch the steering wheel and the mother****er takes off back and forth all willy nilly, I think Fred almost lost a finger!

Wish I could have figured it out before I measured the lines perfectly and zip tied them together. I need to change out two fitting ends tomorrow night, but then it should be ready to rock. (after the sick fab on the grab bar of course...)

[BMFScout]

ram mounted up, the hoses fit better until I had to switch them around, and the grab bar Flemco whipped up.

[BMFScout]

No, the tach doesn't work, big surprise!

[BMFScout]

Nobody wanted to buy my rear bumper so I hacked it down and sucked it in to go back on the Belle. I bolted it up at first to see how much needed to go bye bye, and it stuck out like 1-1/2' on both sides. It looked awesome. I'll post pics later, should be done with it tonight.

[bburris]

I got a ball joint socket from the Snap On man so if you guys want to pull your axle apart to rework anything I can bring it by and lend a hand.

[BMFScout]

Nice! Ask Fred where he got our new one and what he paid for it!