My heater switch started acting up coming off the mountain Saturday night. -End of my Carnage Report.
Quite refreshing after the past two months. It did feel odd Friday night not blowing an...
Type: Posts; User: Fredo
My heater switch started acting up coming off the mountain Saturday night. -End of my Carnage Report.
Quite refreshing after the past two months. It did feel odd Friday night not blowing an...
Karl Manwhore Crouch?
Just noticed this. :D
I would replace all of it with an LS and T56. :D
Fuel injection AND power. :flipoff2:
http://www.droppedaxles.com/CHEVY_AXLES.html#TXTOBJ7D8154322312261
I get it. A two car garage can fill up pretty quick when painting. You pretty much have to be a paint ninja.
Are you planning on wetsanding and buffing this after you spray it, or just run...
Also, I think I remember asking you this before, but did you pull the fenders,hood, doors to cut in the jams with color before shooting the outside?
Wait.....you painted the bed on a different day from the cab? That's a no no with metallics.
I had Chicken Express for lunch. I went on about a 10 year hiatus from there. I got food poisoning from the one in CS off of 6 and no one believed me. Then, like a week later, I was in Dallas for...
I think Valley may now be called Pro-Series. This hitch and sway control setup is identical to mine except I think those are 1000lb bars instead of 800's.
...
Where did your chebby go?
I've got a Valley or a Curt Distribution Hitch. I recommend the round bar hitch instead of the trunnion. I like the way the bars engage the hitch better than the...
Robbie brings up a good point. The snake oil challenge is worth a try.
Lucas is some good stuff. I've got a engine that wouldn't probably be alive without the stuff. Refer to this thread to...
I think you need to just find a rig to put this under and come back to the world of offroading Doug. It's still a lot of fun in case you forgot. :D :flipoff2:
Good to hear Busa. I was worried with all the work, you might have to cancel.
Well, don't take what I'm saying as gospel. I know the crankcase ventilation flutes work better at venting crankcase pressures than the baffles on most engines, but I could totally buy them being...
Those 10mm wires are comical. No 4L in history has needed 10mm wires. :D
Also, you still have the blow-by, I promise. The baffles under that crankcase vent and breather are just slowing it...
You are not supposed to bottom the studs out. Only install the studs into the top of the knuckle by hand. Leave a 16th of slack or so from tight. They are supposed to be in tension, but not...
If this was a saturday run instead of a sunday run, I'd be in. You guys have fun and be careful!
Couple things...
Doodlebug? Really?
Why put all the time into a low pinion, non-high steer front axle? Has that axle even been cut and turned, or does it have negative caster like a mofo? ...
Looking good man! I wish ZF made a transmission that would work behind a 5.3. That thing looks way beefier than the inside of a 4L60e.
MUCHO BUENO! That is starting to look like a truck again!
That's nice.
Hey, who was it that took the pic of Lurch right before the left front chromo shaft exploded in sparks and flying debris? I'd like a copy of it.
Checking the diaphragm is as easy as putting vacuum to it. If it doesn't hold a vacuum, it's bad.
As far as the master cylinder, you can get one of these.
...
It is far too quiet around here for being "Clayton Eve"
Thanks man!