I only had to trim a few inches off each fender, of course I didn't care what it looked like as long as it worked.
Type: Posts; User: Broncocustom
I only had to trim a few inches off each fender, of course I didn't care what it looked like as long as it worked.
That have them at the Avis at IAH. The last couple of times I have flown in they have at least 5 sitting there. I got in early last week and I counted 12 sitting there.
I am glad to hear the old bar is still aound after 10 years and still being used.
I have one of the metal / particle board shelves from Lowes that works good. For the heavy / large items I have shelves made out of 1 1/2" gal. pipe. with 3/4" plywood (gift from El Paso).
They are at an equipment rental place on the north side of 290 outside beltway 8 past 1960.
Call Jason out in Anderson (936-870-5856). I know that in the shop he and Ryan have several toyota third members and they might be willing to sell one.
Behind the shop is were all projects that get delayed are stored or are going to be cashed in for money at the metal yard. Jason has 2 toyota's out there that he basically got for free that are...
I am glad to hear it still runs good. I never did anything to the engine except change the fluids.
Congrats Chris.
They need to be a junior or senior student and is some sort of Engineering degree program.
The last few summers some interns have made more then us because of overtime for the interns that work out in the field.
Scott again...
Matt - Busa's neighbor is also interested - we'll see what he offers.
Scott on James' computer...
The trailer that I want - lowboy with out rails will still be easy to load up with a forklift if I need to - just not by the fenderwells...
Which gas tank is it? Main or Aux
He considers 3 cylinders running good.
But now he can not keep it running unless he keeps his foot on the gas.
The rear end might be done and look good but he is going to need his wife to pull him around the trailer since his engine sucks. Right now it will not start and when it does run only 3 of the 4...
Since the thing does not have fenders you do not have to worry abought tire clearance, so why not take the lift off to lower your COG.
Here is a pic of the support and the pipe is on the passenger side not the drivers which I said before.
On my bumper pull Scott just welded a pipe over the driver side fender to add support. Then I would drive the bronco over that fender and on the deck on the passenger side. It worked great. the...
one drive shaft is 31" and the other is 35".
It has been 4 tires for a while. It started at $1100 for 5 tires. I sold the new one. These tires cost a little over $300 new + tax and shipping. $200 a tire is not bad.
They are in my garage so I will try to remember to measure them tonight.
According to my insurance they will total the truck if the repair cost is more than 65-75% (sometimes they go higher) of the value of the truck. According to the insurance company that truck is...
4 tires, all with the same wear.