Yup it's broke

well after pullin the carrier out and tearing the ez locker out, i think you can see the damage

2

3

now my question is, are some of those holes supposed to be oblong? or is that a result of the broken pins? and any ideas on how to get the broken parts of the pins out of there?

Jackassic might be able to shed some light on this one. He blew up a drop in that bad or worse awhile back.

Mine was close, but I broke all four pins in half and one got jambed in caddy wompus. Lucky for me, it was in a slot where I could get a punch in behind it.

Those slots should be oval but they may still be a little chewed up. I would think that the pins would harder and more brittle than the locker. I bet drilling them would be out of the question.

You might try heating it with a torch, but then you stand the chance of changing the temper of the locker.

Another choice would be to try and weld on the broken pin. then when you have it built up enough, put a nut on the end and weld the nut to the pin. that would give you something to pry on.

that's just a lockright, correct? On mine the holes were round, it looks to me like yours got wallowed out, cause the don't all look the same.

yea, its an ez locker, the pins are loose in there, i can turn them, just can't get them out, i'm goin to try one of those big ass magnets tommorow, i didn't think the holes were supposed to be wallowed out like that, but wasn't 100%

hey man on my ez two of my holes were wallowed out and two were the right size. If you need a small pick set i got one, just let me know.

I did that to an EZ once... then I got a Detroit

3 of you (landon, nick, scott) have broken ez lockers? Anybody else?

Busa broke one, Lynda broke one

Lets see,

Thats 4 broken lunchboxes...

Kollins broke an ARB...

Troy broke a spool...

Anyone broke a Detroit?
























I didn't think so.
-Mark

Why are they called lunchboxes?

oh wait broke the EZ in my CJ now i got a detroit add that one to the list