plus the front gears in the 60 havnt been set yet... i finished the 10.25 a few months back, just need to add caliper brackets to the disc setup
Printable View
plus the front gears in the 60 havnt been set yet... i finished the 10.25 a few months back, just need to add caliper brackets to the disc setup
please, that sh!t is off the burner, in some tupperware, and at the bottom of the freezer under some old meatloaf, a free turkey, and a dead hooker's liver. In 2 years you'll dig it up while trying to find the last blue otter pop, and will throw it away as it is unidentifiable due to freezer burn.
seriously though... i want rear bumper design suggestions
i might build the sliders first because i know exactly what i want in them and i dont see that taking too long... i dont think i can make it across town to the steel yard before they close so i guess i will do that tomorrow... i am going to use 1/4" plate and mount it from the body mounts and then weld a piece like it was dont at 90 with a break... then use some 1" square tube and build a step off it... my wife wants a step and i told her the nerf bars had to go
thanks i guess i could have done that
but actually helpful... jimmy's simple mind makes things easier
I like this one... looks like it 3"x4" box.... i dont know how easy that is to find but i can look... what spindle should i use for the tire carrier?... i will check out TSC for trailor parts to possibly use
Most people I've seen get the spindles and such from trailer places, but there are DIY tire carrier setups you can find online as well.
i am cheap so i will just see what TSC has in its trailor section
use rockstompers...
http://www.rockstomper.com/catalog/pieces/hinge.htm
I think thats pretty reasonable.